Home > News > Content
Moisture Analyzers Simple Operation, Accurate Test
Oct 23, 2017

Moisture Analyzerss can detect all kinds of organic and inorganic solids, liquids, gases and other samples of the water content of the instrument is called Moisture Analyzers, according to the principle of measurement can be classified physical and chemical determination of two categories. The methods commonly used in physical determination are gravimetric method, distillation stratification method, gas chromatographic analysis, etc., and the chemical determination method mainly has the Karl Fischer method, the toluene method and so on, the International Organization for Standardization has set the Karl Fischer method as the standard for measuring trace moisture, Our country also set this method as a national standard to measure trace amounts of water.

The common weight loss Method Moisture Analyzers has halogen moisture measurement, infrared Moisture Analyzers, Microwave Moisture Analyzers, etc.

The common Bell Fischer Moisture Analyzers has the capacity of the Fischer moisture tester and the Coulomb method (Power method) of the Bell Fischer Moisture Analyzerss.

Infrared Rapid Moisture Analyzers, using the principle of pyrolysis weight design, is a rapid water testing equipment. While measuring the weight of the product, the infrared heating unit and the moisture evaporation channel quickly dry the sample, and the moisture meter continuously measures and displays the moisture content of the sample lost in real time, and the final moisture content value is locked to display. Compared with the international oven heating method, the infrared heating can reach the maximum heating power in the shortest time, and the detection efficiency is much higher than the oven method. The general sample can be measured in just a few minutes. And the operation is simple, the test is accurate, the display part uses the red digital tube, respectively may display the water value, the sample initial value, the final values, the determination time, the temperature initial value, the final values and so on the data, clearly visible. and has the ability to connect with the computer and printer.

Can be widely used in all industries requiring rapid moisture measurement, such as pharmaceuticals, plastics, chemicals, food (surimi, dehydrated vegetables, meat and aquatic processing, noodles, flour, biscuits, mooncakes, etc.), food, fodder, seeds, rapeseed, tea and textile, agroforestry, paper, rubber, textile and other industries in the production and experimental process.

Maintenance and maintenance of rapid Moisture Analyzers

In the use of the Rapid Moisture Analyzers to use the finger press button, to avoid nails, but also to prohibit the use of sharp hard objects.

The sealing cover of the rapid Moisture Analyzers should be lightly raised.

Minimum sample size must be greater than 0.5 grams.

When the Rapid Moisture Analyzers is in standby condition, it can be used without preheating.

The Rapid Moisture Analyzers should clean the sample tray before putting the sample, and should use the sample tray bracket at all times, in case of hot sample plate burns.

The last display state of the test remains in the screen until you press the peeled key. The second test should be as soon as possible to prevent water loss.

Use the Halogen moisture tester before carefully check the power supply voltage and halogen moisture tester requirements are consistent, sockets and equipment plug is intact, if there is damage do not use. Please turn off the total power switch before or after work, and do not have the total switch to put the power plug next to the instrument.